Reasons Why Your Water Heater Is Leaking

The water heater is not a device that people tend to think about or often notice. When you have Water Heater Installation Colorado Springs it’s usually just an appliance with the sole purpose of providing hot water for your household needs. However, there are some reasons why your water heater might be leaking, and it’s important to know what they are so you can take the next step in fixing them!

Moen, Delta, and Rheem water heaters are among the most common models that leak. While each has its own set of leaks, there are some general reasons for several types of leaks:

· A rusty tank can cause a leaking water heater; however, it’s rare because tanks are galvanized to prevent rust problems. However, the sediments in the bottom of your tank can result in sediment buildup and clog in the drain valve or dip tube

· When you shut off the water and gas valves but leave them open when trying to carry out repairs on your own is asking too much. You’ll get burned if you don’t do it right the first time around. Shutting off this valve is a simple process of closing the valves, which will result in minor water damage.

· A crack in your tank can lead to a massive mound of dirt and debris that can pile up and cause major leaks. Most water heaters do not have gaps because they are sturdily made with rust-resistant metals and high-grade stainless steel. However, suppose your water heater still gives you problems or breakdowns after being serviced inside and outside by an expert. In that case, it might be time for Water Heater Replacement Colorado Springs.

· If cleaning out sediment from the drain valve doesn’t help stop the leak, then it’s possible that this has corroded over time, and parts of it have rusted through due to corrosion caused by the water. This is an early sign of leakage, so you should act on it as soon as possible before the whole tank corrodes and completely breaks down.

· A significant drop in the hot water supply is another warning sign that your water heater might be about to break down or has already developed cracks internally. As sediment accumulates inside, you will find hotter water decreasing over time until it becomes cold again. If this happens, you need to call a plumber ASAP to save yourself from even more significant losses (not to mention the lack of hot showers).

· You can also tell if your tank has developed leaks by seeing whether there are any rust spots around the unit itself, especially directly under where it is mounted to the wall. If you see evidence of rust anywhere, it’s time to get on the phone with your local plumber.

· A water heater leaking from the bottom is a problem that can be caused by or exacerbated by low levels of sediment in your system, recirculation problems, faulty heat traps, and overworking of the unit. When its tank begins to lose too much heat due to sediment buildup, it will start working harder to supply you with enough hot water for showers and dishes—and this additional stress puts undue pressure on any weak points in the system leading to cracks developing at either end where it stands upright. When cold water returns to the bottom of the unit, it comes into contact with these weakened points and can begin to seep out, leaving a telltale trail on the floor.

What you can do: Install a GeoSpring water heater blanket. It will help protect your tank from drops in temperature and keep sediment at bay. Also, check your home for recirculation problems using a simple test: flush all of the toilets simultaneously and see if hot water appears instantly under your GeoSpring. If it does not, contact a plumber immediately, as this is evidence that some of your water is being rerouted back into the system without being adequately heated.